Re: wireless ip phone roaming without controller and without ACS
If you don't have a split mac address model, it will take longer for the phone to authenticate, associate and roam to the second AP.
Perhaps you can try disabling un used channels on the IP phone so it does not need to scan all the channels, only the ones on use. But still will need to go through an entire process of authentication to the new AP and the associace.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...