IPv6

Hi All,im trying to clarify some confusion with where this is going in terms of show commands for bgpwhen i first played with ipv6 bgp in 12.3 years back, the only way to view bgp v6 items was via "sh bgp ipv6", and this as far as i recall was meant ...

Hi,I want to know what procces should I make to configure an ipv6 addres on a BVI. it only allow me to configure ipv4 address. should I upgrade the ios?RP/0/RSP0/CPU0:ASR9K_PEREIRA#show platform Wed Dec 18 14:26:14.009 UTCNode            Type        ...

I'm configuring two 2800 routers (ADVENTERPRISEK9, 12.4(24)T2) for OSPFv3. The interfaces are Frame-relay multipoint interfaces on both routers. OSPFv3 is fine without authentication. But when I added same MD5 authentication to the two interfaces, OS...

        I have configured IPv6 for clients, i am able to get IPv6 address from configured DHCP server (Win 2012).From client it is showing following link local address as a gateway, i have configured manual address for link local.fe80::1%11I need to ...

My understanding of IPv6 may not be accurate, so if there are any incorrect statements, please correct them.We have a requirement that prohibits FE80::/10 addresses from passing from end sites to the provider network.  FE80::/10 are the IPv6 link-loc...

We are using cisco prime cable provisioning 5.0. IPV4 and IPV6 are disabled in our server. How to enable the docsis 3.0 in all Cisco Prime Cable Provisioning 5.1 (LNX_BAC5_1-RC4-64_20130925_1408_2)Registered Capabilities IPv4 - DOCSIS 1.0/1.1:Disable...

Hi everybody,I looking a way to configure an ASA in 9.1 to permit access from the Internet in IPV6 to an internal server in IPV4.I have already read a lot about this topic and tried several Twice NAT configuration but so far I'm not successful.To res...

My objective is to perfect my knowledge (basic to intermediate at this point) of IPv6 by creating a 100% IPv6 LAN.That's the Windows component - and I have a decent grasp on that.But here's the hitch...My ISP does not yet offer IPv6. Moreover, my tes...

We are trying to setup IPv6 lab / testbed that will be used by companies who planning transistion to new protocol. Is there any one with suggestions or mybee real life experience. any comments are welcome. 

Is it possible to convert ipv4 to ipv6 address when we configure cisco router with ipv4 in one end and that provide ipv6 as an output in other endIf so then please help me with that command...

Hi,Why does Cisco IOS not have "ipv6 default-network" command?Thank you for your cooperation in advance.