IPv6

                   Well please suggest me document where i can read about ipv6. Though i have joined training for ipv6 in one of the best cisco training centres (http://networkerszone.com/) , however needs some cisco documents for detailed study.

Dear Expert,I would like to know that there is no IOS supported "IPv6 SLA for static route track" for ASR or C7606?I have find the alternative solution posted on Oct-2011 (https://supportforums.cisco.com/message/3459644#3459644)I have similar require...

Dear Experts, I have a question about IPv6 deployment. The platform configured to use stateless autoconfigure in router SVI and client get the IPv6 address via RA successfully. DHCPv6 server setup and DHCPv6 relay configured in router SVI for DNS inf...

Hi,The core switch of our company is Catalyst 6509 with SUP2. Last week we change to new Catalyst 6509-E with SUP2T. The configuration of new core switch are almost same with old switch, we have not enable ipv6 routing. But after we change core switc...

I have the following network:I have not configured OSPFv3 yet but all the IPs and interfaces are configured as shown. However I am finding that the show ipv6 neighbors command is not showing anything. My understanding is that this is like the ARP tab...

Hello,In my external interface having IPv6, I like to drop ND so that connected external devices will not get any ND advertisement.What is the equivilant syntex for "ipv6 nd supress-ra" in CISCO ASR 1013 Router having IOS version 15.2. There is no av...

Hi,I want my computer with an IPv6 Address of the block 2800:410:890:1::/64, reach both IPv4 and IPv6 address ( I don't want to use an ipv4 address on my cumputer). I configured and enable NAT_PT for IPv6 on my router.  I cannot ping 2800:410:890:1::...

here is the Router configurationr1# sh runno ip domain lookup!ipv6 unicast-routing!!!interface Tunnel0 no ip address ipv6 address 5001::6001/120 ipv6 ospf 100 area 0 tunnel source Serial2/0 tunnel destination 200.1.1.1 tunnel mode ipv6ip!interface Lo...

Dear All,When I was doing PoC for IPv6 transition, I had to work with NTPv4 for native IPv6. I am using 3825 running 12.4(24)T  adv enterprise.As per Cisco documents NTPv4 is supported in 2 modes.1. Client - Server.2. Multicast.I am presently interes...

Looking to get a router in my lab working on a comcast cable modem.  I am recieving RAs from the ISP router, however my router will not generate its global unicast from the prefixes, regardless of ipv6 address autoconfigGeneral config:!ipv6 unicast-r...

Hi, I'm trying to find out how to use a low-end cisco router (2800/1800/800) as a DS-Lite client side.Is it possible?

Hi, I was reading a lot about different IPv6 transition technologies, but it's most about tunneling or providing an access to IPv4 Internet from  IPv6 only host.What I need is other way around. There is a IPv6 only hosting services, with many service...

Hi everyone,     I have been asked to set up a pure IPv6 test lab environment to see how to configure IPv6 settings in our Layer 3 switches and Layer 2 switches. I have a Cisco catalyst 3750, 2960G, a Dell PowerEdge 1950 acting as my DHCPv6 server, a...

I have a feeling this may have been asked before, but was wondering if there was any roadmap for OSPFv3 or EIGRPv6 routing protocol support on Cisco ASA5500 series devices?Sent from Cisco Technical Support iPad App