Centurylink IPv6 on Cisco RV340

[Rustin B]

I have followed a number of online guides on setting up Centurylink IPv6 6rd on various routers.  I tried the exact same approach on my RV340 and cannot get it to establish an IPv6 connection.  The settings are attached.  I did wonder if a "DHCP-PD" prefix is needed?

I have the connection type set to SLAAC.  Centurylink says their IPv6 6rd is "stateless".  I have also tried DHCP and still no luck.

My IPv4 IP is dynamic, DHCP, has worked fine for years now.  Connection type is gigabit fiber.

[Georg Pauwen]

Hello,

I remember an older thread from a while ago, where it turned out that router advertisement (RA) on the RV340 is turned off by default, and that needed to be enabled...

https://community.cisco.com/t5/routing/cisco-rv340-router-ipv6-on-bt-ultrafast-fttp-set-up-help/td-p/4117201