cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
221
Views
0
Helpful
3
Replies

Configure IPv6 Routes on IE-2000

Hi All,

 

I'm wondering how I can configure a IPv6 default route on a Cisco IE-2000 switch. I enabled dual stack and both - IPv4 and Ipv6 - are working but I cannot find any command to set IPv6 routes?!

 

Any help is appreciated.

 

Thanks, Martin

 

1 ACCEPTED SOLUTION

Accepted Solutions

Hi there,

The command to use would be:

 

conf t
! 
license boot level ip lite
!
exit
!
wr mem
reload

This is only a eval license so is strictly time limited. These switches don't implement the RTU (right to use) model so require a license file to be installed if you want these additional features to remain.

 

cheers,

Seb.

View solution in original post

3 REPLIES 3
Seb Rupik
VIP Advisor

Hi there,

What license is the switch running? IPv6 static routes (and OSPFv3) are only available with the IP Lite license.

 

cheers,

Seb.

Ahh I see, thanks.

 

Index 1 Feature: lanbase
	Period left: Life time
	License Type: Permanent
	License State: Active, In Use
	License Priority: Medium
	License Count: Non-Counted

Index 2 Feature: lanlite
	Period left: 0  minute  0  second
Index 3 Feature: enhancedlanbase
	Period left: 8  weeks 4  days
	License Type: Evaluation
	License State: Active, Not in Use, EULA not accepted
	License Priority: None
	License Count: Non-Counted

Index 4 Feature: iplite
	Period left: 8  weeks 4  days
	License Type: Evaluation
	License State: Active, Not in Use, EULA not accepted
	License Priority: None
	License Count: Non-Counted

Index 5 Feature: mrp-manager
	Period left: Life time
	License Type: PermanentRightToUse
	License State: Active, In Use
	License Priority: High
	License Count: 1/1/0  (Active/In-use/Violation)

Index 6 Feature: mrp-client
	Period left: Life time
	License Type: PermanentRightToUse
	License State: Active, In Use
	License Priority: High
	License Count: 1/1/0  (Active/In-use/Violation)

Tried to activate the evaluation license without success. How can I do that?

 

 

Hi there,

The command to use would be:

 

conf t
! 
license boot level ip lite
!
exit
!
wr mem
reload

This is only a eval license so is strictly time limited. These switches don't implement the RTU (right to use) model so require a license file to be installed if you want these additional features to remain.

 

cheers,

Seb.

View solution in original post