06-04-2015 03:42 AM - edited 03-01-2019 05:47 PM
what cisco hardware support NAT64 configuration ??
06-05-2015 12:20 AM
Hi there,
Stateful NAT64 is only supported on ISR4300/4500 and ASR/CSR1000 routers.
cheers,
Seb.
06-08-2015 10:57 PM
Hi Seb,
Thanks for your quick response.
I have done some research & found ASA with 9.1.1 will help me achieving the same.
Cheers,
Parmanand Patil
06-09-2015 02:03 AM
Hi Parmanand,
You are right the ASA does support NAT64, but it is stateless. For each IPv6 address you will need a corresponding IPv4 address. You will likely need a large pool of private IPv4 addresses to NAT into, these in turn, if requiring internet access, will then need to undergo stateful IPv4 NAT. NAT'ing traffic twice will require a little bit more effort to audit.
cheers,
Seb.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide