07-26-2019 12:15 AM
My setup: ISP - IOS XE - L3 Switch - clients
ISP allocates dynamic IPv6 prefixes via DHCPv6 PD over PPPoE.
If there is no L3 switch, the setup is straightforward:
interface Vlan100 ipv6 enable ipv6 address ISP ::1:0:0:0:1/64
But as we have an L3 switch we cannot directly send RAs to the clients on IOS XE. So is it possible to use our own IPv6 prefix under L3 switch, then NAT66 them to a dynamic prefix allocated from the ipv6 address pool?
I have already tried to use all-zero in the first 64 bit of an IPv6 address in nat66 config and it does not work.
07-26-2019 06:56 AM
I would suggest not using NAT66. Since the SP gives you a PD, you should have sufficient space to configure IPv6 on the XE device and the L3 switches and run routing towards the Internet.
Regards,
07-26-2019 06:59 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: