IP-SLA not allowing ipv6 address, tried all I know..?

[mahenkpatel]

Hi,

I am trying to configure ip sla for floating default route for my IPv6 address. I have already configure IPv6 address on the interface and also enabled IPv6 unicast-routing on the router, still my ip sla command is not allowing me to enter ipv6 address in the configuration. The screenshot will al required info is attached below, if the fonts are too small its attached as well.

Let me know if anyone know what the problem is?

Thanks

[Julio Carvajal]

Hello,

Well, it does not even look like your router support the feature, that's why it's not showing there sr.

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

Check for that specific feature on the IOS Set you have,

And remember to rate all of the helpful posts

Regards,

Jcarvaja

http://laguiadelnetworking.com