cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
355
Views
0
Helpful
1
Replies
Highlighted

IPv6 ND RAGuard on Port-Channel on 2960X Switch

Hi folks,

i've a little question

on a 2960x with 152-2.E7 IOS i want to enable raguard features on gig ports and on the belonging port-channel uplinks.

 

i could successfully create the raguard profile

ipv6 nd raguard policy RAEDGE
!
ipv6 nd raguard policy RAROUTER
trusted-port
device-role router

 


Then i configured the edge port

 

interface GigabitEthernet1/0/47
switchport access vlan 662
switchport mode access
ipv6 nd raguard attach-policy RAEDGE
spanning-tree portfast
end

 

Now i wanne configure the port-channel interface

 

sw001-002(config)#int port-channel 1
sw001-002(config-if)#ipv6 nd ?
% Unrecognized command
sw001-002(config-if)#ipv6 ?
IPv6 interface subcommands:
cef Cisco Express Forwarding for IPv6
crypto Encryption/Decryption commands
dhcp-ldra IPv6 DHCP LDRA information
flow Flow related commands
mld MLD interface commands
multicast multicast
nd IPv6 interface Neighbor Discovery subcommands
traffic-filter Access control list for packets
verify Enable per packet validation

sw001-002(config-if)#ipv6

 

So, the switch shows me that there is a nd sumcommand but it dont allow me to use it. Is this a firmware bug or did i forgot to configure something special ?

 

The used SDM is

sw001-002#show sdm prefer
The current template is "lanbase-default" template.
The selected template optimizes the resources in
the switch to support this level of features for
0 routed interfaces and 1024 VLANs.

 

Maybe somebody has a clue

 

best regards

 

florian

 

1 REPLY 1
Highlighted
VIP Expert

As per the document :

Restrictions for IPv6 RA Guard

  • This feature is not supported on EtherChannel and EtherChannel port members.



BB


*** Rate All Helpful Responses ***

Content for Community-Ad
This widget could not be displayed.