03-30-2023 06:11 AM
When i want to turn on prefix delegation on my router the prefix state stays in Prefix State is SOLICIT instead of OPEN.
GigabitEthernet0/0/0 is in client mode
Prefix State is SOLICIT (3)
Retransmission timer expires in 00:00:03
Address State is IDLE
Prefix Rapid-Commit: disabled
Address Rapid-Commit: disabled
Commands:
(config-if)#ipv6 enable
(config-if)#ipv6 address autoconfig default
(config-if)#ipv6 dhcp client pd FROM-ISP
03-30-2023 07:03 AM - edited 03-30-2023 07:05 AM
Hi @Rottot ,
It looks like you are not receiving any dhcpv6 messages back from your provider. Are you certain they offer dhcpv6 at all?
Can you try getting a dhcpv6 address from them by configuring the following command:
int xxx
ipv6 address dhcp rapid-commit
Regards,
03-30-2023 07:25 AM
The interface has received an ipv6 address via dhcpv6. Also I tried to configure prefix delegation with the exact same commands 2 weeks ago. Back then everything worked fine but now it switched to SOLICIT.
Regards
03-30-2023 07:29 AM
Hi @Rottot ,
If that was working 2 weeks ago and not working now with the exact same config, I would suggest you reach out to your service provider to see if they can help.
Regards,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: