ESC quite often gets to out-of-sync state in NSO. Which causes some extra problems too.
For example, when I try to remove the VNFR (delete deployment) then:
admin@ncs(config)# no nfvo vnfr esc vnf-deployment esc-demo CSRv2 esc22
admin@ncs(config)# *** ALARM out-of-sync: Device esc22 is out of sync
Moreover, after this commit, CSRv2 deployment is still on ESC, while on NSO:
admin@ncs# show running-config nfvo vnfr
% No entries found.
I must be not following some good practices here… thanks for advice