How can I lookup real time bandwidth utilization for specific subscriber?
we have subscribers like that:
#show subscriber session username 100.64.4.248
Type: DHCPv4, UID: 2883, State: authen, Identity: 100.64.4.248
IPv4 Address: 100.64.4.248
Session Up-time: 08:14:30, Last Changed: 08:14:30
Authentication status: authen
Active services associated with session:
name "IPoE10Mbps1SLA", applied before account logon
Rules, actions and conditions executed:
subscriber rule-map IPoE-SUBSCRIBER-CONTROL
condition always event session-restart
10 authorize aaa list IPoE-AAA identifier source-ip-address
subscriber rule-map default-internal-rule
condition always event service-start
1 service-policy type service identifier service-name
Class-id Dir Packets Bytes Pri. Definition
0 In 920627 231996802 0 Match Any
1 Out 1762368 2205745378 0 Match Any
Template Id : 10
Class-id Dir Timeout value Idle-Time Source
1 Out 43300 00:00:00 Peruser
Class-id Dir Packets Bytes Source
0 In 920625 211742640 Peruser
0 In 920625 211742640 IPoE10Mbps1SLA
1 Out 1670470 2031493289 Peruser
1 Out 1670470 2031493289 IPoE10Mbps1SLA
Class-id Dir Avg. Rate Normal Burst Excess Burst Source
0 In 10485500 1966080 3932160 IPoE10Mbps1SLA
1 Out 10485500 1966080 3932160 IPoE10Mbps1SLA
Type Active Time AAA Service ID Name
USR 08:14:30 - Peruser
SVC 08:14:30 1560283644 IPoE10Mbps1SLA
INT 08:14:30 - TenGigabitEthernet0/0/1.502
description "== ACCESS SUBSCRIBERS INTERFACE SVLAN:502 =="
encapsulation dot1Q 502 second-dot1q any
ip dhcp relay information option server-id-override
ip dhcp relay information option-insert
ip dhcp relay information policy-action replace
ip unnumbered Loopback0
ip helper-address 10.1.1.1
ip nat inside
ip flow monitor NETFLOW-TO-COLLECTOR input
no ip route-cache same-interface
arp timeout 43200
service-policy type control IPoE-SUBSCRIBER-CONTROL
ip subscriber l2-connected
initiator unclassified mac-address
CCO documentation lists out the ability to do a password recovery for eXR with a ZTP/PXE boot.
One can also perform the operation manually, like a "turboboot" for classic XR in this facinity.
this procedure will wipe out the complete system and install a...
Below is a link to a video showing how to analyze traceroute output in L3VPN and look up CEF forwarding and MPLS/TE/SR/SR-TE forwarding for labels through a domain. Some basic examples of traffic engineering are used but the concepts lend the...
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...