The CE should tag the frames with two vlans (one management, one production).
I am planning to use xconnect on sub ATM interfaces to the VPLS on the backbone.
I have 2 issues:
1-the CE1 will tag the frames with a vlan that is different from the VPLS vlan. for example CE1 tag frame with vlan 2004 and xconnect to PE1 in VPLS vlan 4000 at PE2 it is again translated to 2004 but in the response the packet will be forwarded to PE1 with VLAN 4000 and then xconnect to ASR with vlan 4000 and sent in ATM to CE1.
2- is there a way to extract the management vlan from the ATM PVC?
The version of ASR is asr1000rp1-advipservicesk9.03.03.02.S.151-2.S2.bin
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...
Technical Guide to Pre-Defined NAT.
In traditional NAT, due to the government regulations logging the CGN translations is mandatory and this is a huge cost incurrence. In Pre-defined NAT, the translations are known upfront, hence there is no nee...