04-12-2022 06:43 PM
We are using a mLACP with an ASR920 router in an Active/Standby configuration.
The opposite device will be a Catalyst switch (stacked), but we have the following on the Catalyst switch side
Is it necessary to set lacp max-bundle 1 and lacp port-priority to match?
If not, I would appreciate an answer to that question.
■ASR920#1 (Active)
interface Port-channel1
lacp fast-switchover
lacp max-bundle 1
mlacp lag-priority 10
mlacp interchassis group 1
■ASR920#2 (Standby)
interface Port-channel1
lacp fast-switchover
lacp max-bundle 1
mlacp lag-priority 100
mlacp interchassis group 1
■Catalyst Switches
interface Port-channel1
lacp max-bundle 1
!
GigabitEthernet 1/0/1
lacp port-priority 10
channel-group 1 mode active
!
GigabitEthernet 2/0/1
lacp port-priority 100
channel-group 1 mode active
04-12-2022 11:49 PM
04-20-2022 07:05 PM
Thank you very much.
I understand that lacp port-priority and lacp max-bundle settings are not required on the Catalyst switch.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide