configuring traffic policing and shaping per vlan on ME3400E switch with MetroIPAccess image
How do I configure per vlan traffic policing and shaping per vlan on an ME3400E switch with MetroIP Access image?
I tried configuring a policy-map, but that can't be assigned to a virtual interface.
I have an ME3400E and currently have a router that is managing the bandwidth for one of our customers, I wanted to remove the router and configure the ME3400E to do the routing since it is a layer 3 switch, but I can't figure out how to limit the bandwidth to 15MB for vlan 301. We have another vlan that uses the remainder (85MB) of internet access.
How can I configure the ME3400E to limit both ingress and egress bandwidth to 15MB for a specific vlan?
This is what I tried:
ME1(config-pmap-c)#police cir 15000000
ME1(config-pmap-c)#int vlan 301
ME1(config-if)#service-policy input 15MEG
Configuration failed. Policymap is not supported on virtual interfaces
Most of our ports are access ports and so I can configure the bandwidth management to the physical interface, but the port for our customers that want internet access is a trunk port and I need to be able to limit the bandwidth per vlan (so if customer a (vlan 101) pays for 10MB I can limit them to 10MB and if customer b (vlan 202) pays for 20MB, I can limit their vlan to 20MB
Any help would be greatly appreciated! Thanks in advance
I'm not sure I understand your example. Say I have one customer - VLAN 301 - that is paying for 15MB of internet access and another customer - VLAN 300 - that is paying for 10MB of internet access, and they share port g0/11 - which is configured as a trunk port and allows VLANs 301 and 300. How would I configure the switch to make sure each customer gets the bandwidth they pay for, but only what they pay for. We are not using class of service at all. We just want to be able to rate limit (traffic policing and shaping) the traffic per customer (VLAN).
loadbalancing is one of the more complex items in hardware forwarding. of course we have talked about it many years on cisco live (id 2904) with ever incrementing more detail. and there is the support forum article on loadbalancing.
IntroductionArchitecture Building BlocksIOS-XR RoutersConfigurationPerformance VerificationOptimizationStrict timerSome more verificationThe CollectorInfluxDBDatabase statistics and HealthClosing comments
This document was written in collaboration with:
IOS-XR MPLS TE Auto Tunnel Backup Bandwidth Protection Current Implementation of MPLS TE Auto Tunnel BackupPotential issue with current implementation of MPLS TE auto tunnel backupEnhancement to MPLS TE auto backup in IOS XR 7.5.1Supported HardwareConfig ...
we are trying to monitor the Cisco 9148s SFP status, and have get the Sensor's dBm value from the CISCO-ENTITY-SENSOR-MIB table, meanwile , it has an Index value like "30000xxxx",such as "30001773", entsensorValueTable but we can't sure how to l...
Check out our latest release on Cisco Routed Optical Networking solution. Listen: https://smarturl.it/CCRS8E24Follow us: https://twitter.com/ciscochampion Disruptive network transformation may only happen once a decade. First movers c...