How can I measure my maximum throughput from the leased line that I got from ISP?
I don't know if this is the right forum.
So I work for a Service Provider, and we got 2 new internet leased lines over fiber(LACP), 2x10 Gb from another department(same entity) not so far from us, I Port-Channeled those two to my Cisco Firepower, and tested the internet throughput with speedtest.net, which I don't think is the best way, but I don't know any other way to measure, how should I measure?
remember the link itself is 20Gb but how much internet data I can flow over it, is different, it supposed to be the same, but it wasn't according to speedtest.net, I ran a concurrent test with 3 laptops(gb network adapeter) at the same time, and it wasn't.
This guide will explain how to check where a particular directory resides within the filesystem in terms of physical disk, logical volume, volume group, etc by taking a look at where the install repository actually resides on an NCS5500.
According to the RFC 7432:
Extended Community enables split-horizon procedures for multihomed sites. The ESI Label field represents an ES by the advertising PE, and it is used in split-horizon filtering by other PEs that are connected to th...
In scaled EVPN deployments it can be wise to name ESI that way to represent the site/physical port/etc it is attached to. Thus on some remote location you can easily verify where particular route/MAC is coming from. Similar to phone numbers, where...
Want to enable Feature EPFT with “routing-protocols-enable”. However ,it is throwing an error and ask to configure the following command: “non-subscriber-interfaces mac” which once enabled drops the traffic without any penalty.
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"