Hi
I was tried to configured an ASR901 access port for my customer POC in ASR 901 but fail.
It does not support for switchport access VLAN commad .
I have suscessful setup a port-channel in ASR901 to the Alcatel switch and the LACP is up and in bundded state.
The question is how can I configure a access port mode (VLAN 100) in ASR901? The PC will need to
perform a PC Ping test from the ASR901 access port to the ALU Access port via the port-channel that I have configured.
I try to plug in my PC to the port Gi0/4 then run the Ping test from my PC to another PC that connected to Alcatel switch but fail as well.
PC (VLAN 100) Gi0/4 --- ASR901 --(LACP)--ALU --- PC (VLAN 100)
ASR901 configuration
interface Port-channel1
no negotiation auto
service instance 10 ethernet
encapsulation dot1q 100
bridge-domain 10
!
service instance 20 ethernet
encapsulation dot1q 200
bridge-domain 20
!
!
interface GigabitEthernet0/0
no negotiation auto
service instance 10 ethernet
encapsulation untagged
bridge-domain 10
!
interface GigabitEthernet0/1
negotiation auto
channel-group 1 mode active
!
interface GigabitEthernet0/2
negotiation auto
channel-group 1 mode active
!
interface GigabitEthernet0/3
speed 100
duplex full
no negotiation auto
!
interface GigabitEthernet0/4
no negotiation auto
cdp enable
service instance 10 ethernet
encapsulation dot1q 100
rewrite ingress tag pop 1 symmetric
bridge-domain 10
!
!
interface GigabitEthernet0/5
speed 100
duplex full
no negotiation auto
service instance 20 ethernet
encapsulation untagged
bridge-domain 10
!
!
interface GigabitEthernet0/6
speed 100
duplex full
no negotiation auto
service instance 10 ethernet
encapsulation untagged
bridge-domain 10
!
!
interface GigabitEthernet0/7
no negotiation auto
service instance 10 ethernet
encapsulation untagged
bridge-domain 10
!
Tq
