IP PRISMA and tagging

[anasmomo]

Dear All,

I have a network consists of 4 sites, kindly see the attached drawing.

The four site connected to each other using SDH network.

But the problem is that from the Catalyst 6500/FWSM side the WAN is appears as a shared single subnet. And for example to reach site C from A. I don't know which path is used.

Is it possible to redesign this network so that I can control the traffic on the ring and perform load balancing.

I am thinking to implement a new catalyst switches between the FWSM and the IP Prisma in each site and configure a trunk link that tags two WAN VLANs; so that for example from Site A will be two logical interfaces one for site B and one for site A.

Is the Prisma support this design? Or is there any other good idea?

Best regards

[anasmomo]

Can any one help me

Ana

[Pavel Bykov]

VLANs is a good idea for control, you can create L3 circuits instead of L2 circuits.

I'm not sure about IP PRISMA though :(

Normally on shared circuit the balancing/replication is done using L1 methods, so IP Prisma would be definitive in this case.