cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1333
Views
0
Helpful
2
Replies
Rastislav Fukas
Enthusiast

L2VPN Bridge of PW type 4 and type 5 pseudowire

Hello

is it possible to bridge different pseudowire types in one bridge domain in ASR9000? I'm interesting especially in this type of configuration where one PW is in VFI and other is directly under bridge domain

Thank you

Rasto

 

l2vpn
!
 pw-class PWC_ETH
  encapsulation mpls
   protocol ldp
   transport-mode ethernet
   ipv4 source 10.10.10.1
 !  
 pw-class PWC_VLAN
  encapsulation mpls
   protocol ldp
   transport-mode vlan passthrough
   ipv4 source 10.10.10.2
 !
 bridge group BG1
  bridge-domain BG1
   interface g0/0/0/0
   !
   neighbor 10.10.20.1 pw-id 21 
    pw-class PWC_ETH
   !
   vfi VF1
    neighbor 10.10.30.1 pw-id 31
     pw-class PWC_VLAN
   !
  !
 !

 

1 ACCEPTED SOLUTION

Accepted Solutions
Rastislav Fukas
Enthusiast

I tested, it is not possible to mix different types of pw in one bridge domain

View solution in original post

2 REPLIES 2
Rastislav Fukas
Enthusiast

I tested, it is not possible to mix different types of pw in one bridge domain

View solution in original post

Correct, that is not supported. All PWs must be of the same type.

 

Elvin

Content for Community-Ad

This widget could not be displayed.