I'm having issues trying to get VLAN Bandwidth Limiting to apply only to one particular VLAN. I can get the rate limiting to work on the customer port along with the service provider port, but on the service provider port the rules seem to apply to all VLANS not just the one in particular. When pushing traffic across the VLAN201 in this example, the downstream traffic is limited to 5Mb but should be applied to that VLAN. This is making me scratch my head as to why the rule is applying across all VLANS and not just the 1112 in this example:
class-map match-any vlan_1112 match vlan 1112 ! policy-map LIMIT class class-default police cir 5000000 conform-action transmit exceed-action drop policy-map UPLINK-LIMIT class vlan_1112 service-policy LIMIT
Symptoms: the root password can't log in by GUI Solution:1) login CLI as admin2) write command "ncs webroot enable" without qutations3) we can check the status by "ncs webroot status" hope this will help someonethanks
ISO images are as close as we can get to the old school classic IOS images from back in they day.
Doing upgrades by putting a new image on the flash, changing the boot pointer and reload was and is still the walhalla of Cisco based devices.
Is this LTE card tied to specific provider such as Verizon or ATT. If I buy one of these for Verizon carrier, and later decide to move to ATT. Can I replace the software image to support ATT vendor? or will have to buy a new LTE card specific f...
Service flow verification and forwarding troubleshooting have just been made much easier with the introduction of the XR Embedded Packet Tracer framework.
The first platform on which this functionality is supported is the ASR9000, starting with rel...