cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
900
Views
0
Helpful
0
Replies
Julie Tupling
Beginner

ME3400E egress bandwidth management

With help from this site, I was able to figure out ingress bandwidth management on a per port basis, but now I need to be able to configure egress bandwidth management.  I think I need to do traffic shaping but am not sure.  I was told that if you configure the bandwidth management using a percentage, that it doesnt' use the actual negotiated (or configured) port speed, but looks at the bandwidth interface command - is this true?  If a port is set to autonegotiate, and comes up as a GigE port, but the bandwidth command is set to 100Mbps, if you configured the egress shaping to 10% would that set it to 100Mbps or 10Mbps?  We are using the ME3400E to provide internet access to our customers - egress bandwidth management is very important !

0 REPLIES 0