cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1608
Views
0
Helpful
2
Replies
Highlighted
Beginner

Policing Priority Queue on ME3800

I’m trying to add a QoS for each service instance to prioritize traffic on ME3800. Below are the config im trying to use, however I’m getting error when applying it.

policy-map Child-Policy

  class CM-Voice

    priority

    police cir percent 35 bc 25 ms pir percent 35 conform-action transmit exceed-action transmit violate-action drop

< snip >

policy-map Parent-Policy

class class-default

    shape average 50000000

       service-policy Child-Policy

ME3800(config)#interface GigabitEthernet0/1

ME3800(config-if)#service instance 1 ethernet

ME3800(config-if-srv)#service-policy output Parent-Policy

QoS: Configuration failed.  Police is NOT supported in output policy

QoS: Configuration errors for policymap Parent-Policy

If I remove the "police cir percent 35 bc 25 ms pir percent 35 ..." on the class CM-VOICE and just leaves the "Priority" the policy is accepted on the interface.

However I will not be able to control the amount of traffic for Voice. Is there any way that I can achieve LLQ and limiting the amount of traffic?

Any help will be much appreciated. Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Which software release you are using?

Egress Policing on the PQ is supported in 15.1(2)EY1 and later images.

View solution in original post

2 REPLIES 2
Highlighted
Beginner

Which software release you are using?

Egress Policing on the PQ is supported in 15.1(2)EY1 and later images.

View solution in original post

Highlighted

Thanks Waris!

12.2 version. We'll upgrade to 15 in a few days.

Content for Community-Ad

This widget could not be displayed.