Dear All,
Please i need help to keep my job.
We needed a router that will replace our 7206VXR so we went for ASR1002-X which management said was too expensive. We now went for ASR903 without checking its ability to do what the traditional IOS routers do.
Now i need the ASR to do router on a stick for me while having BGP peering to 2 service providers.
Can someone translate the configuration below to ASR903 version since it doesn't support sub-interface but Ethernet Virtual circuits (EVC) and bridge-domain interface.
Config on 7206VXR
interface GigabitEthernet0/1.275
description TEST
encapsulation dot1Q 275
ip address 10.128.3.97 255.255.255.252
no cdp enable
ip route 41.X.X.X 255.255.255.255 GigabitEthernet0/1.275 ----------> 41.X.X.X is Single IP given to clients
Please help
Regards
Udensi