I hope everybody is doing fine. Learning VPLS implementation on cisco, I have a few questions for you guys , I can not perform this lab in GNS3, and the books I have been reading do not address these questions.
no ip address
switchport access vlan 111
l2 vfi cust-one manual
vpn id 1
neighbor 10.100.100.2 encapsulation mpls
neighbor 10.100.100.3 encapsulation mpls !
no ip address xconnect vfi cust-one
1) Let say PE1 above receives a frame, it is untagged on f4/22,
PE1 notices that port is a part of vlan 111, PE1 therefore looks up MAC table for vlan 111, PE1 determines that frame need to be forwarded out on a PW,
My question is ::Will PE 1 add Vlan tag 111 before forwarding out that frame on a PW ?
2) May i say every time a frame needs to be sent out of PW defined under " interface vlan xx", Vlan tag XX is added to the frame ?
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...
Technical Guide to Pre-Defined NAT.
In traditional NAT, due to the government regulations logging the CGN translations is mandatory and this is a huge cost incurrence. In Pre-defined NAT, the translations are known upfront, hence there is no nee...