el 08-19-2020 12:34 PM
Hola,
Tengo un problema tengo un Ap modelo AP-1562I-A-K9 que no me permite agregar a la controladora mobility express que tengo instalada en un AP2802I-A-K9 con una versión 8.10.130.0 marcándome los siguientes errores:
[*08/19/2020 18:06:15.2983] Stopped Radio 0
[*08/19/2020 18:06:15.3307] Stopped Radio 1
[*08/19/2020 18:06:15.3352] SYS-COND: Bringing down radio wifi0
[*08/19/2020 18:06:15.3352] SYS-COND: Bringing down radio wifi1
[*08/19/2020 18:06:15.3352] SYS-COND: AP is in critical condition
[*08/19/2020 18:06:15.6886] DOT11_CFG[0] Radio Mode is changed from Bridge to Bridge
[*08/19/2020 18:06:15.6893] DOT11_CFG[1] Radio Mode is changed from Bridge to Bridge
[*08/19/2020 18:06:16.4053] dtls_init: Use SUDI certificate
[*08/19/2020 18:06:16.4057]
[*08/19/2020 18:06:16.4057] CAPWAP State: Init
[*08/19/2020 18:06:16.4064]
[*08/19/2020 18:06:16.4064] PNP is not required, Starting CAPWAP discovery
[*08/19/2020 18:06:16.4064]
[*08/19/2020 18:06:16.4066]
[*08/19/2020 18:06:16.4066] CAPWAP State: Discovery
[*08/19/2020 18:06:16.4073] IP DNS query for CISCO-CAPWAP-CONTROLLER.xxxxxx.com
[*08/19/2020 18:06:16.4130] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*08/19/2020 18:06:16.4130]
[*08/19/2020 18:06:16.4130] CAPWAP State: Discovery
[*08/19/2020 18:06:16.4147] Discovery Response from 10.248.180.251
[*08/19/2020 18:06:16.4247] TLV-DEC-ERR: cannot process TLV for TLV_EXPIRE_MIC_TYPE_PAYLOAD(661/0)
[*08/19/2020 18:06:16.4247] TLV-DEC-ERR: No CB for TLV_EXPIRE_MIC_TYPE_PAYLOAD(661)
[*08/19/2020 18:07:31.0000] can't find the Ip from discoveryRequest array
[*08/19/2020 18:07:31.0000]
[*08/19/2020 18:07:31.0001]
[*08/19/2020 18:07:31.0001] CAPWAP State: DTLS Setup
[*08/19/2020 18:07:31.3737]
[*08/19/2020 18:07:31.3737] CAPWAP State: Join
[*08/19/2020 18:07:31.3752] Sending Join request to 10.248.180.251 through port 5272
[*08/19/2020 18:07:31.3785] Join Response from 10.248.180.251
[*08/19/2020 18:07:31.3786] AC rejected join request[10], try again later.
[*08/19/2020 18:07:31.3786]
[*08/19/2020 18:07:31.4627] HW CAPWAP tunnel is ADDED
[*08/19/2020 18:07:31.4786]
[*08/19/2020 18:07:31.4786] CAPWAP State: Image Data
[*08/19/2020 18:07:31.5137] do PRECHECK, part2 is active part
[*08/19/2020 18:07:31.6594] Image Data Request sent to 10.248.180.251
[*08/19/2020 18:07:34.4179] Re-Tx Count=1, Max Re-Tx Value=5, SendSeqNum=1, NumofPendingMsgs=1
[*08/19/2020 18:07:34.4179]
[*08/19/2020 18:07:37.2688] Re-Tx Count=2, Max Re-Tx Value=5, SendSeqNum=1, NumofPendingMsgs=1
[*08/19/2020 18:07:37.2688]
[*08/19/2020 18:07:40.1196] Re-Tx Count=3, Max Re-Tx Value=5, SendSeqNum=1, NumofPendingMsgs=1
[*08/19/2020 18:07:40.1196]
[*08/19/2020 18:07:42.9714] Re-Tx Count=4, Max Re-Tx Value=5, SendSeqNum=1, NumofPendingMsgs=1
[*08/19/2020 18:07:42.9714]
[*08/19/2020 18:07:43.6538] Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Image Data(10).
[*08/19/2020 18:07:45.8214] Re-Tx Count=5, Max Re-Tx Value=5, SendSeqNum=1, NumofPendingMsgs=1
[*08/19/2020 18:07:45.8214]
[*08/19/2020 18:07:46.0890] Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Image Data(10).
[*08/19/2020 18:07:48.6722] Re-Tx Count=6, Max Re-Tx Value=5, SendSeqNum=1, NumofPendingMsgs=1
[*08/19/2020 18:07:48.6722]
[*08/19/2020 18:07:48.6722] Max retransmission count exceeded, going back to DISCOVER mode.
[*08/19/2020 18:07:48.6728]
[*08/19/2020 18:07:48.6728] CAPWAP State: DTLS Teardown
[*08/19/2020 18:08:59.4296] do ABORT, part2 is active part
[*08/19/2020 18:08:59.5525]
[*08/19/2020 18:08:59.5525] CAPWAP State: Discovery
[*08/19/2020 18:08:59.5536] IP DNS query for CISCO-CAPWAP-CONTROLLER.xxxxxxx.com
[*08/19/2020 18:08:59.5588] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*08/19/2020 18:08:59.5595] Discovery Response from 10.248.180.251
[*08/19/2020 18:08:59.5671] TLV-DEC-ERR: cannot process TLV for TLV_EXPIRE_MIC_TYPE_PAYLOAD(661/0)
[*08/19/2020 18:08:59.5671] TLV-DEC-ERR: No CB for TLV_EXPIRE_MIC_TYPE_PAYLOAD(661)
[*08/19/2020 18:09:09.0000] can't find the Ip from discoveryRequest array
[*08/19/2020 18:09:09.0000]
Espero y me puedan ayudar.
Gracias
el 08-20-2020 09:48 AM
Hola @fkceres
De acuerdo al release note de la versión el AP 1562 no es soportado por el AP que actua como WLC
Puedes revisar la tabla 1.
Espero que la información haya sido útil y si no tienes más preguntas recuerda cerrar el topic, seleccionando la respuesta como "Respuesta correcta"
**Please rate the answer if this information was useful***
**Por favor si la información fue util marca esta respuesta como correcta**
Descubra y salve sus notas favoritas. Vuelva a encontrar las respuestas de los expertos, guías paso a paso, temas recientes y mucho más.
¿Es nuevo por aquí? Empiece con estos tips. Cómo usar la comunidad Guía para nuevos miembros
Navegue y encuentre contenido personalizado de la comunidad