Created by: Midhun Sunny on 08-06-2010 09:35:02 AM Hi I am trying to develop a mobile application and can i use the same commonservices.dll to get all the APIs as i have done in my web application Thanks Midhun
Subject: RE: Developing a mobile application using the context aware api and Dotnet Replied by: firstname.lastname@example.org (simulated) on 15-10-2010 05:25:42 AM
I am trying to develop a mobile application and can i use the same commonservices.dll to get all the APIs as i have done in my web application
Hi allI'm trying to add Tags through netconf to an Access Point on a WLC98k (17.3.1).Here is the code:from ncclient import manager
insert_ap_cfg_data = '''
Hi, When I use:x.x.x.x/api/location/v1/clients/count/byzone/detail?zoneId=xxxThe Response is:"Sorry, Zone details are available in debug mode only. Use /api/config/v1/zoneCountParams/1 API to set debug mode ": "" I need a CMX API to count the nu...
Hi All,I am looking for Meraki API support for turning on 802.1X on MS Switches. I looked at the documentation here https://developer.cisco.com/meraki/api/#/rest/getting-started - but could not find the AccessPolicy Related APIs to configure 80...
Question about configuring a Cisco CMX server in HA using a Virtual IP (VIP) Is the Virtual IP address just used for management of the CMX HA servers, the admin GUI, or does the active node use the VIP for all communications, for example for Location...
Hi there, Need to find a list of devices that have been Whitelisted on the Meraki Dashboard. I can see Whitelisted devices that are currently connected to the network, Network-wide > Clients - Policy- drop down tab ...