6500 Sup2t/DFC4: Q-in-Q/Service Instance over PWE3 Circuit for transparent EPL
I'm trying to setup a solution where I can provide an Ethernet circuit, allowing the customer to push whatever tags they want into their frames by using Q-in-Q to push an S on the PE and then carry that double tagged frame through a Pseudowire.
One of the nodes is a converged PE/CE 6500VSS with Sup2t and DFC4 cards. I know that the 7600 requires certain cards to support these features, but would this work on the 6500 with these cards?
I think the configuration would look something like this:
I would be potentially terminating the remote end on a Juniper MX with a CE switch downstream and would likely trunk VLAN 600 from the MX into the CE switch and then present VLAN 600 as an edge Q-in-Q tunnel port.
Theoretically this should carry the traffic end to end and allow for any VLANs to be pushed into the Pseudowire?
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...
While gNMI is fairly new, it's becoming more and more powerful. Its abilities to simplify network management by the use of protocol buffer files and standard definitions are enabling our customers to integrate a lot ...
Today we are releasing to the public a tool to help find differences in command outputs in two points in time (IE pre and post MW).
The issues we are addressing is what commands to gather and how to successfully parse the data when timestamps, upti...