Those who have dealt with ME3600X switch, can you tell me if I need to purchase the “Advanced Metro IP Access License” in order to run L2/L3 MPLS VPN? The license is $3995 in addition. It is a big cost for us. More specifically, I want to know if the...
DearsWould like your assistance regarding below plzI was wondering how MEF E-line, E-LAN & E-tree services are configured at Cisco ?? What come to my mind is that first we need to have MPLS network then implement these services as below E-line ---...
Does this router support MPLS with the default image installed? If not which, for feature/version should I look licence in order for the router to support MPLS?Here is the router info from Cisco website:CISCO892-K9 - Cisco 892 Gigabit Ethernet Securi...
Dear AllI need help to understand the WRED configuration on the Core Network Interfaces(10 X 1GE Line Card) on a P Router (Cisco 12K) for congestion avoidance.What are the guidelines for determining the Min and Max Threshold values and the Mark Proba...
Dears,Although I have always used this command ... today is the first time I ask myself how it worksIt seems I miss somethingHow does "match tag" works with "export map"I am asking this cause "tag" doesnot appear except with static routes .... and ex...
Hi,i am trying to set up TE tunnels with Fast Reroute protection. As i am using FastEthernet and GigabitEthernet links i need to use RSVP Hello for link or node failure detection. I have a little problem understanding and properly configuring the rsv...
I'm trying to understand HOW net 172.16.4/24 became preferred via 10.0.0.2 in VRF REG3.It appears (to me) the decision was made based on lowest METRIC value. I see the (metric) was set somewhere in the MPLS cloud (I think) but cannot discover how/why...
TOPOLOGY:I have a dual Hub and Spoke MPLS topology, with a Point-to-point link between the hubs. Traffic between spokes must traverse one of the hubs in order to reach the destination spoke. Spoke-to-spoke traffic works as designed. :QUESTION:I want ...
Dears, I would like to know If VPLS multihoming redundancy feature is avilable at Cisco or not ? have a CE connected to two different PEs for redundancy. PEs are configured in a VPLS mode. At steady state only primary PE should carry traffic ... xSTP...
We are a small regional service provider and did not have MPLS supported on our network. To start supporting MPLS, I’d like to get opinions and recommendations on the best practice configuration. Here is what we have today –We have our own BGP AS a...
Hello,I have a little question, I'm studying MPLS using GNS3. I made a network with 4 MPLS routers, each connected to 2 others MPLS routers and one external non-MPLS router.I try to hide all the internal MPLS routing using the "no mpls ip propagate-t...
