MPLS

Hello,at between 2 CPE routers there are 4 routers from an MPLS Backbone. The total distance should be around 10000 Km. I need some reference values for the acceptable RTT between the two endpoints. Is there any reference table or Doc. describing it ...

Dear All,I have issues with static routes towards P2MP tunnel.Here's my config:interface Tunnel234 ip unnumbered Loopback0 ip pim passive ip igmp static-group 225.1.1.1 ip igmp static-group 225.1.1.1 source 10.10.10.2 tunnel mode mpls traffic-eng poi...

Hi All,I am considering a Cisco 7204VXR router to do MPLS VPN. In my design, there will be two PEs, in between is a 1Gb link where multiple customers will share.On both PEs, I need a switch where each individual customer will connect in via one port....

Good day Dear AllI work for an ISP and i want to setup a mpls vpn solution for our customer. We use use Cisco router everywhere and we our Client CPE are form other vendors.This is my problem1- I want to setup a cisco 7200 router as BRAS so that our ...

Has anyone used uplink interfaces on ME6524 to deliver xconnect (port based)? The configuration is supported but am not sure how the performance would be, have no test environment and hence cannot test. Suggestions would be much appreciated.Cheers

Dear All I'm trying to configure a csc scenario with 3 routers. Two routers at the edge presents the customer carriers while the 3rd router in between presents the backbone carrier. at the 3rd router ( the backbone carrier ) I configured vrf and assi...

HelloI just watched a strange thing - there is basic MPLS connection between PE1 <-> P <-> PE2 Router and I sniff outgoing messages from PE1 in this scenario. MPLS is enabled global with "ip cef" and also on all interfaces with "tag-switching ip" com...

I have setup a basic MPLS lab and am trying to get R1 and R11 to run RIP over the VRF PALMI am running OSPF inside and BGP between PE1 and PE2 I believe why R1 cannot ping R11 is that routes are not being passed between BGP because of the same AS?PE1...

HiI could help with the configuration of VPLS in the ME3750 because I find the settingsfor that computer and does not appear, or I might say if it is used for the 7600 router?

Hi all experts. Can someone explain me what is the meaning of aggregate when i do show mpls forwarding table. I tried searching here but it seems its meaning changes in different contexts. Like in mpls vpn, it means that this packet is for a VRF and ...

Hi all experts.If an ISP has a customer with 200 branches, and that customer wants all his branches to be provided layer 2 connectivity, means it wants a full mesh at layer 2 just like ethernet, so that there is no need for Tunnels and the client is ...

We have layer2 AToM working in our lab:CE-2941--to--PE-2811--------PE-3825--to--CE-2941question is:how does one configure one point-to-point PE layer2 tunnel that does not require the same VLAN tagging for the CE's VLAN, or different CE non-tagged VL...

Hi my problem is DR flapping basically DR changes from one PE to another, in my current environment I have about 8 PE so recently I see this log messages. This is effecting muticast traffic.  Jun 14 09:01:38.758 MY: %PIM-5-NBRCHG: neighbor 10.0.32.36...