MPLS

ATM over MPLS/ MPLS over GREHello,I have following situation:ATM----CE ---PE=====PE----CE-----ATM The PE are operator M320 Juniper routers the CE are our 7609 routers with SUP 720 and SIP-200 where the ATM is connected. The operator provides us only ...

I am a customer who has the following set up:37501-----CE1----PE1-MPLS-PE2-----CE2---37502 A GRE tunnel runs from 37501 to 37502.The problem I'm having is that I have a primary and backup link from CE1-PE1, and when it failsover to the ba...

Hi,Here is the configuration attached.My question is this if i will c the report for class utilization ..its comes like 500 to 5000 % ..can you please explain what does it mean...class utilization can we more than 100%%.class-map match-all cm_class4 ...

Hi Srs.any body knows if Cisco has implemented on any plataform The TDM over mpls implementation aggrement compliant in the mpls forum?. I`m Trityng to tranport tdm circuits (DS0) over mpls backbone. I know that pwe3 permit us transport layer 2 circu...

Good dayI have a problem that needs a solution, and I hope someone out there can help me :-) I need to be abe to do NAT for data going from the a customer VRF into the Internet VRF.I've leaked the routes between the two VRF's, configured the NAT stat...

Hi,Do cisco routers (10K,GSR,7500's) assign labels per vpn route ?Can they assign label per vrf ?The reason for this query is my concern of scalability when using Option B (RFC 4364 Sec 10.) as compared to Option C. ThanksImran.

HelloI have experienced the following situation recently. It hasn't fixed yet. If you have any idea, please advise. Any comments are welcome!The problem was that the voice packets have been dropped in class Voice despite the fact that the interface'...

We are a ADSL service provider In part of our network all DSLAMs are connected to a switch DSLAMs are working in L2 mode I want to seperate customers using VLANEach customer will have unique vlan and for evry vlan there will be a subinterface on rout...

Hi all,I work for a small company with 8/9 POPs in various locations all connected via Ethernet back to our central locations.We're at the stage of integrating 2 disparate networks at the moment (one running EIGRP, one OSPF, the greater number of dev...

Hi Sir,Due to inconsistent result during my customer UAT TE link FRR. All the 3 PEs (C7609) link are connected in triangular (three different POPs). From PE-to-PE it's interconnected via DWDM devices. In this scenario, how can we know what type of me...

Dear All, I am having to configure a GRE tunnel between aCisco 2600 and SUP-720 acting as MPLS PE. GRE CE (2600) <--------> PE (SUP-720) The tunnel interface on the SUP-720 is in a VRF and I can connectto the other interfaces connecte...

Hi All,I am new to implementing VRF.Could someone suggest me good docs to start with?Thanks