MPLS

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

I have a scenario where multiple customers ethernet links are getting terminated on one switch and one of the trunked GBit port of switch is connected to a router Gigabit Ethernet port. Gig port is configured for dot1q encapsulation with suinterfaces...

Hi,can MPLS load-balance ? (when using OSPF as IGP there is a possibility that 2 prefixes will be reached with equal cost...). And what if a router has several links to the same router ?Thank you

Hi, recently we've been start pushing our MPLS IP-VPN and VPLS solution to some customers, while most of them reluctant to have a revamp to their network infrastructure (most of them running on frame-relay). I tend to think that me myself can't find ...

What is the minimum software version for Cisco 2620XM to execute mpls?I am running Version 12.2(24)but enable to run mpls command.1)Router(config)#tag-switching advertise-tags2)Router(config)# interface e0/1Router(config-if)# tag-switching ipPls help...

sam-lee by Level 1
  • 3234 Views
  • 8 replies
  • 0 Helpful votes

Hello All, We have deployed VPN's via ethernet and we integrate that via dot1q VLAN's on a subinterface on a GigEthernet. We then make those a member of a specific vrf forwarding VPN for example. interface GigabitEthernet0/1.101 description VPN-CUST1...

hiSomebody knows How can I connect some vlans from switch2 to switch1.. Actually I work with lan switching but I need work with MPLS. Thanks for help me to solve my trouble

jcamacho by Level 1
  • 459 Views
  • 1 replies
  • 0 Helpful votes

HiI'd like to know if anybody knows an URL describing the maximum dimension (in terms of supported number of VRF, routing processes, routes, etc) of a PE (family 7xxx and upper).Tksric

Hello,if configuring OSPF for a VRF you cannot configure passive interfaces! The command does not even exist!This seems to be related to CSCeb86068.Does anyone have experiences with that issue??Any intelligent solution??ThanksJuerg

jjtanner by Level 1
  • 708 Views
  • 3 replies
  • 0 Helpful votes

I have some question:1.MPLS traffic engineering use opaque (LSA type 9,10,11) to get eg. BW of the link!But in OSPF , when there is a change in an area, the LSA will flood to all. So if there is an application transfer a file on the link, the BW will...

abusayyaf by Level 1
  • 1386 Views
  • 4 replies
  • 0 Helpful votes

Hi All,we recently bought a IPSec VPN SPA card for a 7606 (720 3bxl) and we want to implement the following service on the router.We want to connect IPSEC VPN tunnels through the internet and based on their peer-id terminate traffic on the correspont...

pavlosd by Level 2
  • 707 Views
  • 2 replies
  • 0 Helpful votes

HI guyz, i got 2x 2501, 1x 2522, 1x 2621, 1x 3620... wat IOS needed or any other router need for CCIP home lab??? my router all with max flash & dram..... Please advice..Thnks,

william2u by Level 1
  • 1076 Views
  • 5 replies
  • 0 Helpful votes
Top Solution Authors