MPLS

HI we have 7200 series router having mpls connectivity , we are able to open some sites but not able to open the other. what may be the possible cause , we have change the router , pc, also but the problem is same , and when we trace and ping the sit...

Hi All.I have two routers PE connected. In the first one I have two VRFs and second one I have two VRFs too.In the PE1 and PE2 I have VRF CPD01 and NOC01.In the VRF NOC01 I have five routesI need to export only one route from NOC01 to VRF CPD01. What...

What will happen if LSP is broken....Will the packet dropped or IP routed????Consider that no reroute mechanism is configured as such.....THNXRAJ

Hi thereI wonder if it possible to transport a QinQ across an EoMPLS connection, so the EoMPLS is transparent to the QinQ (ie. transport a trunk of VLANs across the EoMPLS connection)?

Hi,Does anyone know the equivalent command in Cat.OS ?no logging event link-statusBest regards,Peter

We are in process of converting all over site to MPLS from Frame relay. Most of the applciation see better response. But One applciation by LXE ( for warehouse management,,using Cisco AP technology) can not run properly. ( Only at startup - It will n...

Customer hub site has two CE routers with two links connected to two seperate PE routers in the Carrier's MPLS network. At the customer's remote site one CE router on a single link is connected to PE router in MPLS network. How can I configure the CE...

Hi thereIs it possible to run a CES (Circuit Emulated Service) over a MPLS network?I know it's an ATM terminology, but I wonder if it's possible...Cheers,Lars Christensen

Is it possible to have multipoint topologies with FRoMPLS? In other words, if I'm receiving some Frame Relay PVCs on one physical interface on a PE, can I transport some of them to one remote PE and others to another remote PE? Or do I need to have s...

Hi,I'm looking for good, advanced level MPLS training. What I expect is:. Scaling BGP and OSPF as IGP. Migrating extising IP infrastructure to MPLS (LDP switched). . Migrating extising VRF Lite or tunnel-based VPNs to MPLS VPNs. Planning for and impl...

need a better definition between B and C. Not being a BGP expert is probably where the problem lies. I under A and B but am confused on the difference between B and C. Does C only apply when you have multiple links between ASBR's? For a BGP ques...

Hello All,I will try my best to explain my network scenario,see I am have A and B router A is at my location and B is at remote location from A to B we have connected via 2Mb*2 leased lines.At remote location I have server and from there it is going ...

rd is used to make the address distinguish,but i think use the rt , it can achieve the same purpose,so why do we need both of rd/rt?

Hi experts, we are building a mpls core. The problem is our PE is facing hundreds CE. The traffic from each CE may contain several applications and I have to separate them to diffenent VRF in PE.Do you have any good sulotion about that especially for...