Hi can anyone explain when i am using mpls over gre am not able to ping ce end ip from any remote PE .12.SRb5 and also SRD2 seriesis any architecture issue .
Forum Posts
Resolved! MPLS vpnv4 mp-bgp
Dear all, i am running MPLs vpnv4 using mp bgp. my CA1 and CA2 both are running ospf protocol on vrf CA and on PE router on both sides i redistribute the routes form ibgp to ospf and ospf to ibgp. My question is that in CA routeing table th...
Plz anyone can help in configuring cisco BRAS to match on PPPoE domain part to be used to inject it under specific VRF.
Topology:-----------------------------------------------------------------CE1 <---> PE1 <---> PE2 <---> CE2 Configured as:-----------------------------------------------------------------CE1 [ Linux Box ] has default route to PE1. CE1 is connected to...
Working on a MPLS SP lab. It appears I am unable to establish 2 way ldp session between my Juniper SRX and Cisco 2901. My SRX shows an ldp neighbor, but my 2901 does not. Output below. I'm sure this is likely an issue with the SRX and I am awaiting f...
My PE use label per VRF mode: mpls label mode vrf PROV_QADeviceConnect protocol bgp-vpnv4 per-vrf In this case, can I still assign a static label for this VRF? The label static binding command requires an IPv4 prefix there. Even after I configured it...
Hi all I have the following topology: On R3 I have a xconnect to R1 with a backup xconnect to R2. Something like this: interface gigabitethernet 0/1 xconnect 10.1.1.1 1000 encapsulation mpls backup peer 10.2.2.2 1000 R3 sees both neighbours, R1...
Resolved! Help for a network design
Hi, We need some help about network design. We have 3 mainly services: VPN L2 point-to-point links Customer type A than must use Internet link type A Customer type B than must use Internet link type B So far, we have use default routing table in ro...
Resolved! MPLS with VLAN
Help MeHOW ????? Transmission b/w VoIP to VoIP and DataCenter to DataCenter by using switch (VLAN) in MPLS systemI tried Router on Stick method but i am confuse The Below Topology (not real just understanding)
Hi, I understand that an LFIB entry should have a pointer to the adjacency table for L2 rewrite instructions. I thought this was always the CEF Adjacency Table, but I'm not 100% sure if show adjacency detail in IOS is actually showing the CEF adja...
What could be the issue when a link connected to 2 WAN port IP 10.234.253.129 does not come up on the production router but works on a test router. The config on the 2 WAN port are okay. ken-nai-edc-pe01#ping vrf voas001 10.234.253.129 rep 50 Type ...
Hi , Is wan service providers and isp providers are same or different.if they are different how they are different. Regards rammon
Hi Guys What EVPN does , VPLS Doesn't , what is the use case of both thanks
Let's say I have hub and spoke topology over WAN. So a bunch of Branches that have routers (spoke) and connect back to the main router (Hub). We have MPLS service from our ISP, but we also run BGP. Now my question is why? Why if we are already connec...
Hi everyone, MPLS over pure IPv6 network used to be one of the Cisco and IETF roadmap to come. Has it been implemented on different Cisco OSes so far and if it has been I would like to know whether L2 & L3 VPNs can operate on this infrastructure ...
