MPLS

Hello Everyone, Just trying to get an xconnect between two 3650 to work, but I can not ping between the customer sides. I think the MPLS/LDP part is fine as it shows UP on both sides: R#sh mpls l2t vc    Local intf     Local circuit              De...

I am wondering if anyone has seen the same issue I have on several ASR 100x-X series routers when issuing a reload command from the console port to reload the device. I am dialed in via PSTN/modem and issue the reload command, but 1) the RP/Router ne...

I have following topology R1----------R2----------R3 R1 is ASR 9000 series router and R3 is ASR 900 router. Both are enabled with segment routing. I created one l2vpn xconnect from R1 to R3 which is not coming up. Below is the configuration of both...

Hi, A customer is testing a pseudowire between an ME3600 and an ASR9001. PW works without a problem, but they found a curious situation. They decided to generate l2 control protocol flows within that PW (STP, CDP, etc). In the TG-->ASR9001--->ME360...

Hi,Does anyone know if spoke to spoke label allocation will take place in an MPLS over DMVPN environment (for LDP and TE) ?Thanks,David

Hello All, Refer: attached network architecture design I have a network design as attached. Currently we are migrating from IPv4 to IPv6 in our organization & are stuck with one issue. Below is the config from Cisco 6509 catalyst switch for your re...

I have an edge-facing PE router that has a full table inside vrf inet.  That edge PE speaks MP-BGP as an RR to a few other PEs that don't have the capacity to handle a full table but need access to the world via vrf inet.  Those PEs receive internal+...

Hi! everyone  Can anyone share about L2VPN ?

I'm scratching my head on this one.I can ping/traceroute from all other network devices to Router B but can't ping/traceroute from Router B to anything else. Everything on Router B's lan can route to all other devices and the internet etc but the rou...

Hi, I'm looking for ideas for how customers are connecting to VPWS handoffs. Currently, we have an MPLS DMVPN phase 3 solution. A conversion to VPWS will negate that as it is point to point. I'd like to get some ideas such as equipment used by the c...

Hi , i have failed telnetting to ASR 9912 from switch c3850 . even though i can ping The gateway. Thanks on advance 

Hi, I am still trying to grasp the concept of the rotue-target and the route-distinguisher and had a couple of questions.I understand that the Route-Distinguisher is basically used to allow overlapping address space between different customers in MBG...

I have the topology as shown in the image above, in which I have configured VPN over an MPLS network, in which the two customer edge routers cannot communicate.  Routers R2 and R3 are my provider edge routers and R1, R6 are my customer edge routers....