MPLS

I have a router with a VRF SVI that I need bound to another site with a pseudowire. The SVI is in a VRF, the LDP interface with all the bindings is in the global table. Is there a way to bleed it over to allow the VRF interface into the global LDP so...

Hi Any link or documents shows how to troubleshoot MPLS L3VPN connectivity between customer sites spreading to different ISP over inter-AS link based on option C , all PEs in both ISPs are ASR9K Platform   thanks to all and MXMASS

Hi, all, i'm trying to configure P2MP MLDP LSP with in-band signaling and i'm using that guide for configuration. Configuration doesn't include root configuration Network's scheme CE1 - PE1 - RR3 - PE2 - CE2 CE1 - mcast receiver CE2 - mcast source vr...

Good day networkers, Referring to this document: http://goo.gl/6w8Ro7, below is the way to configure DLCI to DLCI L2VPN:  configure terminalframe-relay switchinginterface serial slot / subslot / port [. subinterface]encapsulation frame-relay [cisco ...

Hi all, I have an ASR1002 running 'asr1000rp1-adventerprisek9.03.11.01.S.154-1.S1-std.b'. In regards to LDP, everything I have read is that the router determines the LDP router-id based on the loopback interface with the highest IP address. In thi...

   Hi to everyone.    The RFC 3031, which describes MPLS, says that label distribution is performed only by the downstream LSR. Well, when building a simple MPLS domain I see that label distribution is performed by the downstream AND upstream LSRs.  ...

Hi all I was reading in one of Cisco Live sessions about this feature , I want to implement this feature for VPLS autodiscovery and Manual MPLS L2VPN I have tried the commands (global and under service instance) , but if anyone implemented this in pr...

Hello I made port limitations on the Cisco switch. But it does not work properly. It fluctuates at speed. This may be the cause. What kind of limitations should I do? What should I do to download and upload is stable.

Hi all I have the below topology: CE1 -- CSR1 -- CSR2 -- CE2     |  ----     \  CSR3  / I have configured full mesh iBGP between the CSR routers under the l2vpn vpls address-family Below is the respective VPN configuration: CSRs: l2vpn vfi context MS...

Dear Sir/Madam, >I have been facing vrf fluctuation issue on unified mpls environment. >I have been checked all possible relevant parameters VRF on CISCO ASR 903 & 9000 router but unable to find RCA of fluctuation on given time frame. >As per client ...

It can't ping WAN size 1600. How should I do? interface GigabitEthernet0/0 description WAN TO PE ip address 10.4.254.6 255.255.255.252 ip virtual-reassembly in max-fragments 64 max-reassemblies 1024 load-interval 30 duplex auto speed autoend BDI154...

Hi all,I would like to do some route leaking from VRF to Global and Global to VRF on the same router. Here is an output of the config: interface FastEthernet4 description ***Connection to WAN*** ip vrf forwarding FVRF ip address 10.0.0.6 255.255.255....

Hi All, Just after some general advise on an MPLS design decision. A large enterprise is to have a MPLS infrastructure that contained multiple data centres, and branch offices. The data centres would have firewalls, but the branch offices would not. ...