MPLS

We have 6500 sup 720 with MPLS configured and FWSM in transparent  mode. We also terminate GRE tunnels on the same 6500. After implementing the command “mls mpls tunnel-recir” GRE tunnels are hardware switched (which we want them to be), but we don’t...

Hi Actually we are implementing a network with a solucion VSS Catalyst 4500X the diagram is the follow: when I put on loop 2 ports on the same device the port doesn´t block and verifiying the spanning tree whe looking that port forwarding packets. We...

Hi,Problem: Howto configure EoMPLS L2VPNs on Nexus7000 for Layer2 VLAN Trunking ?    I have TWO HW and SW identical Nexus 7009 with Sup2E running under NX-OS 6.2(2a) with HW Modules: Mod  Ports  Module-Type                         Model            ...

Hi there, setting up RFC3107 (BGP Labeled Unicast) we run into the problem, that intra area traffic is always handled by the Area Border Router (ABR) acting as the inline Route Reflector (RR1). This is our setup:         RR2       |PE1----P1-----ABR1...

Hi, is it possible to establish RSVP-TE tunnel destined to secondary (not primary) loopback address? I have configured 172.17.10.102 as secondary loopback on some ASR. Now, when I try to establish RSVP-TE tunnel to that address from other node, it fa...

Which method would be better: use one 10G link, or combine multiple 1G interfaces?Does anyone know about any pros or cons in using each method?Thank you very much.

HiI have two mpls links on single router configured in ospf. One is for data traffic and other one I want to use only for Videoconferencing with my other office'ss VC devices. There are obvious Static IPs for VC devices in all remote locations.At one...

Freinds, i'm confuse with these terms, what is the End to End LSP and what is seamless MPLS, where we need to use each of these designed.. Thanks alot.

I have an MPLS xconnect pseudowire running over an MPLS-TE tunnel between an ASR9000(IOSXR) and an ASR920(IOSXE). When the pseudowire re-routes the ASR920(IOSXE) drops link protocol on the ethernet port. It seems there is a link pass-through enabled,...

Hi,Good day to you. Is PCEP supported on ASR1K IOS XE?if no, is it included for the upcoming roadmaps? regards, Mohamed Amin

Howdy,  So I have a small issue in my lab.I have setup H-VPLS with BGP autodiscovery. All cicruits are up, everything seems great. Problem is I only get 1 way traffic. From Test_A, I see the mac address from Test_B. I dont see the other way round. Ho...

SITE A / B RTR -- b2b cable -- CE on BGP -- PE to MPLS cloud, on this setup the tunnel is not going down even when we shut the BGP neighbourship interface , why ? because of b2b cable ? then how to track the link and find it is down  

Hi community,Actually trying to build a network monitoring tool, i noticed that some MIBs are not supported on my platform particularly MPLS-FTN-STD-MIB.SNMP requets sent replies with " no such object available on this agent at this OID"I was wonderi...