05-30-2013 02:55 AM
HI guys:
SPA-2X1GE-V2 module interface can work L2 switchport?Thank's
same:
!
interface GigabitEthernet5/1/1
switchport
switchport access vlan 20
switchport mode access
05-31-2013 02:03 AM
Hi there,
no the SIP400 cannot be configured as L2 switchport (it does not make any difference which SPA you actually use).
However you can have multipoint Layer 2 bridging service by using bridge-domain under service instance configuration (EVC)
something like:
interface GigabitEthernet5/1/1
service instance 1 ethernet
encapsulation dot1q 20
bridge-domain 20
Internally one bridge-domain is mapped to one of the 4K global VLAN resource; meaning that you still need a SVI for the L3 termination.
i.e:
Interfaca vlan 20
ip address 10.0.0.0 255.255.255.0
regards,
Riccardo
05-31-2013 03:06 AM
Thank U!
05-31-2013 03:31 AM
you are welcome.
please rate and close the question if useful
Riccardo
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: