Hi there,
I have the following situation with dot1q tagged traffic accross an MPLS network:
Customer trunk with different vlans(CE)----->dot1q-tunnelport with access vlan 83(PE)--->trunk with vlan 83 and some other(on same PE)---->Trunk interface with vlan 83 and some other(on MPLS router)---->SVI VLAN 83 with no ip address and xconnect to other side of the pseudowire.
Is it possible to get the customers vlan's to the other side? It does not work ( I use a ME 6524 as MPLS router) but maybe that is due to the use of dot1q-tunnel and after that a trunk to transport it further. The trunk puts an extra VLAN on the frames but that should work I think. Every mtu size on every router in the path has been increased, also the MPLS mtu size. The VC's are up, that is no problem.
Any idea?
When I change the trunk on the PE to a dot1q tunnel port with access vlan 83 and the interface on the MPLS router to a Portbase pseudowire it works fine.
Thanks in advance.
Regards,
Gert-Jan van der Lee