Hello,
I would like to know if is possible to configure a CSRV 1000V (IOS XE) as a VPLS hub with two Cisco 7200 or 7600 router as shown in the attachement.
Not being very familiar with VPLS, I would like to know if any of the two configurations would work on the CSRV 1000V side
Configuration 1
l2 vfi TEST manual
vpn id 10
mpls no-split-horizon
bridge-domain 10
neighbor 12.12.12.12 encapsulation mpls
neighbor 8.8.8.8 encapsulation mpls
interface GigabitEthernet0/0/0
load-interval 30
speed 1000
no negotiation auto
no clns route-cache
service instance 10 ethernet
encapsulation dot1q10
rewrite ingress tag pop 1 symmetric
bridge-domain 10
Configuration 2
l2vpn vfi context TEST
vpn id 110
member 8.8.8.8 encapsulation mpls
bridge-domain 10
member vfi TEST
member GigabitEthernet0/0/0 service-instance 10
interface GigabitEthernet 0/0/1
no ip address
negotiation auto
service instance 10
encapsulation dot1q 10
7200 Configuration
l2 vfi TEST manual
vpn id 777
neighbor 8.8.8.8 encapsulation mpls
int gi0/0.10
xconnect vfi TEST
Thanks for your help
Stephane