cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3278
Views
5
Helpful
4
Replies

Incompatible tunnel type in BGP update

sungy
Level 1
Level 1

PDT: %MDT-4-INCOMPATIBLE_TUNNEL_TYPE: Incompatible tunnel type in BGP update router_id:192.168.201.10 RD:1200:12 type:1; local tunnel_type:0

added a new PE. double checked configuration and it looks same as other PE.

4 Replies 4

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Sungy,

I would suggest to check the IOS version of new PE it is likely newer and the message may be originated by this fact (different BGP defaults)

Hope to help

Giuseppe

sesoerensen
Level 1
Level 1

do you have "ip pim ssm default" on both IOS boxes?

biju.kesavan
Level 1
Level 1

What range you are using for the SSM? Probably a good idea to specify the range if you using outside the default SSM range. Sample config below - modify the range as per your assignments. Cisco IOS software allows SSM configuration for an arbitrary subset of the IP multicast address range 224.0.0.0 through 239.255.255.255.

!

ip pim ssm range SSM-Range

!

ip access-list standard SSM-Range

permit 224.0.0.0 0.255.255.255

!

arulgobi1
Level 1
Level 1

%MDT-4-INCOMPATIBLE_TUNNEL_TYPE: Incompatible tunnel type in BGP update router_id:5.5.5.5 RD:2.2.2.2:10 type:1 tunnel_type:4; local tunnel_type:0

 

Thanks , saved my time its the mis match between SSM range.. after correcting the SSM range tunnel came up .

 

DR change from neighbor 2.2.2.2 to 19.19.19.19 on interface Tunnel1

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: