cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
664
Views
0
Helpful
0
Replies

IRB with EomPLS

lee.reade
Level 4
Level 4

Hi,

I have a requirement to do IRB alongside EoMPLS, and am looking for some guidance if it is indeed possible.

The setup is as follows;

CISCO3925 with all host connections on the onboard EHWIC-D-8ESG-P with 152-4.M1.

VLAN 2000 ----- ETHPORT1 --- EoMPLS -- CORE--SVI DEFAULT GW

                       |

              IRB    |    

                       |

VLAN 2001 ----- ETHPORT2

The EoMPLS part is staight forward, this works fine, so the client uses the default gw at the core headend where the EoMPLS terminates. I require the new vlan to also be part of the same routed network as VLAN 2000.

However I am not sure if the IRB would work, since it relies on the BVI for routing into/out the bridge domain?

Anyone care to offer any advice?

Thanks,

LR

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: