01-05-2016 06:59 PM
Hi there.
If there were two customer, and RD is set the same both side on the each PE device.
what if we don't set the RT, is it working? or without RT, they can't talk each other?
IF they can talk, it means we only need to set the RT when we need to talk different VPN site(different custoemer). Am i right ?
Thank you.
Best regards,
Solved! Go to Solution.
01-06-2016 05:30 AM
Hello,
"Without RT" means "no export RT" and "no import RT", right?
In that case, if two PE routers have a VRF defined without any route-target commands whatsoever then the communication will not be possible, and here is why:
Best regards,
Peter
01-06-2016 05:30 AM
Hello,
"Without RT" means "no export RT" and "no import RT", right?
In that case, if two PE routers have a VRF defined without any route-target commands whatsoever then the communication will not be possible, and here is why:
Best regards,
Peter
01-06-2016 05:36 PM
Thank you very much !!
01-10-2016 07:15 PM
There is the exception of a VRF Lite configuration. With this method the VRF is declared on all routers from end to end including the routing protocols. The drawback is the extra configuration and management needs so it isn't practical for large networks.
01-19-2016 03:23 AM
as a side note you can do this on junipers using policies rather than route targets
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: