We have few doubts on MPLS based L3VPN and request your help to get them resolved:
1)I had gone through some MPLS docs which suggest that Loop back based MPeBGP peering is not possible .However I am not convinced and request your views on the same. If it is really not possible what is the reason behind the same.
2)Is it possible to run MPLS L2VPN and MPLS L3VPN on the same physical interface of the service providers PE router.
ISO images are as close as we can get to the old school classic IOS images from back in they day.
Doing upgrades by putting a new image on the flash, changing the boot pointer and reload was and is still the walhalla of Cisco based devices.
Is this LTE card tied to specific provider such as Verizon or ATT. If I buy one of these for Verizon carrier, and later decide to move to ATT. Can I replace the software image to support ATT vendor? or will have to buy a new LTE card specific f...
Service flow verification and forwarding troubleshooting have just been made much easier with the introduction of the XR Embedded Packet Tracer framework.
The first platform on which this functionality is supported is the ASR9000, starting with rel...
6PE OverviewThe Cisco 6PE solution enables IPv6 domains to communicate with each other over an MPLS IPv4 core network. MP-BGP in the IPv4 network is used to exchange IPv6 reachability information along with a label for each IPv6 prefix announced. 6PE rout...