07-13-2005 01:39 AM
Wanted to convert the existing live router to P router. But due to router have only one FastEtherent only, I decide to change that port to trunk port, create new VLAN to attached to PE router.
My question is , it is possible to configure "tag-switching ip" on sub-interface, and does it work ?
Normally we configure it at physical FE and WAN interface.
Regards.
07-13-2005 04:30 AM
This works on most platform. What platform are you using?
Thanks,
07-13-2005 07:06 AM
I am using Cisco 7206VXR and Cisco 3745.
Thanks
07-13-2005 08:52 AM
It should work just fine then as long as the specific interface or PA supports dot1q encapsulation.
Hope this helps,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: