cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1851
Views
0
Helpful
1
Replies

MPLS VPN Peer-Group

Hi All,

          I will be most grateful if anyone could please clarify if the below config makes the MYP an IPv4 peer-group member of a VPNV4 peer-group memeber?.

router bgp 1

no synchronization

neighbor MYP peer-group

neighbor MYP remote-as 1

neighbor MYP update-source Loopback0

neighbor 10.0.0.2 peer-group MYP

no auto-summary

!

address-family ipv4 vrf VPN1

redistribute ospf 10

no auto-summary

no synchronization

exit-address-family

!

address-family vpnv4

neighbor MYP activate

neighbor MYP send-community extended

neighbor 10.0.0.2 peer-group MYP

no auto-summary

exit-address-family

My point of confusion was, why was the peer-group configuration deployed under the routing process (IPv4) and at the same time under the VPNV4 configs?. Is this practical?.

Any assistance with clear explanation shall be greatly appreciated,

Olu

1 REPLY 1
Peter Paluch
Hall of Fame Cisco Employee

Olu,

Can you perhaps be more specific in what is your question? I am not sure I fully understand what you are asking about.

In any case, on my 2691 12.4T IOS, I was not able to enter the neighbor MYP activate in the address-family vpnv4 section - the command was refused with the comment

% Peergroups are automatically activated when parameters are configured

The neighbors appear to require individual activation for address families. Instead, I had to activate the neighbor 10.0.0.2 in the appropriate address family. Your configuration as displayed was not identical to what I had in my configuration - after putting in your configuration, this was the result:

router bgp 1

no synchronization

bgp log-neighbor-changes

neighbor MYP peer-group

neighbor MYP remote-as 1

neighbor MYP update-source Loopback0

neighbor 10.0.0.2 peer-group MYP

no auto-summary

!

address-family vpnv4

  neighbor MYP send-community extended

  neighbor 10.0.0.2 activate

exit-address-family

!

address-family ipv4 vrf VPN1

  redistribute ospf 10 vrf VPN1

  no synchronization

exit-address-family

Best regards,

Peter

router bgp 1
no synchronization
bgp log-neighbor-changes
neighbor MYP peer-group
neighbor MYP remote-as 1
neighbor MYP update-source Loopback0
neighbor 10.0.0.2 peer-group MYP
no auto-summary
!
address-family vpnv4
  neighbor MYP send-community extended
  neighbor 10.0.0.2 activate
exit-address-family
!
address-family ipv4 vrf VPN1
  redistribute ospf 10 vrf VPN1
  no synchronization
exit-address-family

Content for Community-Ad