Multi-VRF Load Balance can be possible?

[mhiyoshi]

Dear all,

Currently I am tackling with the following topology.

Based on this, it is pingable between R3 and R2 Global route through MP-BGP based multi-VRF, however I am curious about actually which VRF (VRF-A or VRF-B) can be selected on this condition?

The routing table is like this.

I appreciate if there is any hash mechanism.

Best Regards,

Masanobu Hiyoshi

[Jaderson Pessoa]

Hello,

post here result from:

R3: show ip route 10.0.10.0 255.255.255.0
R2: show ip route 10.0.20.0 255.255.255.0

[mhiyoshi]

Hi Jaderson,

Thank you for your quick reply. Here is the output.

[Jaderson Pessoa]

ok.. they are has the same metric, but now you want check the bgp attributes for each of these routes.

show ip bgp in both routers will show to us which neighbor will be used.

[mhiyoshi]

Hi Jaderson

Here is the show ip bgp output.

[Jaderson Pessoa]

well..

from R2 the best path to network 10.0.10.0/24 is: 10.0.10.1

post the same command from R3 and we know the best path used from both routers.

[mhiyoshi]

Hi Thank you for your support.

Actually R3 has only default route so it does not have any BGP peer.

Regards,

Masanobu Hiyoshi

[balaji.bandi]

Depends on which VRF you learning the routes, can you post full config of R1. ( suggest to post all config to understand your config).

[mhiyoshi]

Hi here is the MP-BGP configuration

[LonGene Leonard]

Via Import and Export targets. LonGene Leonard