03-26-2015 08:21 AM
Hi all,
How can I implment QoS (Marking and Bandwidth reservation) over EoMPLS ? The customer is connected to PE (Cisco 7600 Series): NTU(Customer) --> Aggregation Switch (vlan) ---> PE (SVIs/Subinterface)
Thank you in advance.
Best Regards,
Aaziz
03-27-2015 03:37 AM
Hello.
Could you please provide:
- running configuration of CE-facing interface;
- show ver;
- show module;
- what is your core-facing interface/LC?
03-28-2015 06:33 AM
03-28-2015 11:21 AM
Hello.
Sorry, I didn't get how G0/0/0/4 (does it exist on 7600?) could be a CORE facing interface?!
Did I understand correctly: is your question about inbound and outbound QoS on PE device (CE facing interface)? If not - could you please clarify?
03-31-2015 03:53 AM
Hi Vasilii,
Thank you for your reply.
The Core-facing interface configuration is as follow:
interface TenGigabitEthernet7/1
mtu 4470
bandwidth 10000000
ip address 172.16.0.4 255.255.255.252
no ip redirects
no ip proxy-arp
ip router isis ISISCORE
load-interval 30
carrier-delay msec 0
mpls propagate-cos
mpls ip
bfd interval 100 min_rx 100 multiplier 3
isis circuit-type level-2-only
isis network point-to-point
isis metric 5 level-2
isis authentication mode md5
isis authentication key-chain KEY-ISISCORE
isis bfd
service-policy output 4class
You are right about my question: it's a about inbound and outbound QoS on PE device for EoMPLS.
Best Regards,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: