cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
878
Views
0
Helpful
3
Replies

Remote LFA Tunnels End Points Query

rocky2024
Level 1
Level 1

Hello Friends,

Please help me to understand below outputs. I tried a lot but i am not understand IP FRR concept i.e PQ operations etc..

 

how these end points came in this output of show isis fast-reroute remote tunnels

please help me to understand. only two FRR commands are there under ISIS

router isis access10

fast-reroute per-prefix level-2 route-map IPFRR
fast-reroute remote-lfa level-2 mpls-ldp

 

in route-map IPFRR, tag 10000 value mentioned for incoming prefixes 

 

show isis.JPG

 

 

3 Replies 3

Abzal
Level 7
Level 7

Hi,

From the output looks like router has calculated two alternate paths for prefixes tagged with access269 over TE tunnels. It means that prefixes are reachable over those nexthops without going across primary link. 

Are you using full-mesh TE tunnels?

 

https://www.cisco.com/c/en/us/support/docs/multiprotocol-label-switching-mpls/ldp/212697-loop-free-alternate-and-remote-loop-free.html

Best regards,
Abzal

Hello,

 

sorry for delay in reply

 

No we are not using MPLS TE tunnels.

 

we are using IP FRR Remote LFA tunnels which is on IGP (isis) based.

so I am trying to figure out end point IP calculation which is based on P, Q calculation but not able to digest till now.

please help me and let me know if you need any outputs..

 

thank you!!

 

Hi,

Let me try to explain.

Steps:

1. Find PQ node

2. Targeted LDP session

3. Exchange LDP labels

 

First of all remote LFA is based on PQ extended nodes(a router that is both Extended P-Space and Q-Space is a PQ node).

Extended P space router is - the set of routers that are reachable from one or more direct neighbors of S, except primary node E, without traversing node E.

Q node is set of routers that can reach destination router without traversing a failed link.

PQ nodes are remote LFA candidates. A source router will stack LDP labels on top to reach PQ node and bottom label to reach Destination router via PQ node.

helpful links:

https://www.ciscolive.com/c/dam/r/ciscolive/us/docs/2016/pdf/BRKRST-3020.pdf

https://tools.ietf.org/html/rfc8102#section-2.2.1

https://www.cisco.com/c/en/us/support/docs/multiprotocol-label-switching-mpls/ldp/212697-loop-free-alternate-and-remote-loop-free.html

 

Best regards,
Abzal
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: