bridge-domain 100 member GigabitEthernet3 service-instance 100 member vfi MSSK
service instance 100 ethernet
encapsulation dot1q 100
switchport trunk encapsulation dot1q
switchport mode trunk
interface vlan 100
ip address 10.10.100.1 255.255.255.0 (CE2 is configured with 10.10.100.2)
Now , the issue is that when I shutdown CSR3 G3 interface (Connected to CE1) , I lose connectivity between the CEs even though the L2VPN is established among all PEs , as well , when I check the show bgp l2vpn vpls all I cannot figure out which one is preferred
Cisco Champion Radio · S8|E9 Innovations to Achieve a Trustworthy Infrastructure
How do you know for certain that a router in your network has not been altered with since you deployed it? Wouldn’t it be great if you can cryptographically challenge your r...
IOS upgrade on asr9xx mandates rommon upgrades sometimes while they can be optional at other times. You may land up in unwanted situation if proper procedure is not followed during upgrades.
This article will include complete details about rommon ...
In some situation NCS560 RP become unresponsive after reload or powercycle.
In many deployments NCS560 far edge, deployment is large and human intervention should be kept at minimum
Engineering team have been working on a strategy to have functi...
In simple terms, 'Route Churn' is defined as the 'rate of change of prefixes'. Different XR versions across 4.x to 7.x have differing behavior & support for the BGP churn handling and some enhancements made from 6.5.3 onwards (listed in appendix) mak...
Prior to Cisco IOS XR Software Release 7.1.2, XR dual RP devices did not support file mirroring from active RP to standby RP. Administrators had to manually perform the task or use EEM scripts to sync files across active RP and stand...