VPLS on 12.2.33SR using PA-POS-OC3

[yuchenglai]

Hi Everyone,

I was wondering if anyone know it is possible to run VPLS on 12.2.33 SR when using a PA-POS-OC3 module ?

David

[Giuseppe Larosa]

Hello David,

a PA is installed on a FlexWAN module that is an adaptation of C7500 VIP linecard to C7600 architecture.

As a result of this, VPLS should not be supported.

A confirmation of this fact is given by the Flexwan configuration guide that does not mention VPLS but only AToM in the MPLS chapter.

see

http://www.cisco.com/en/US/docs/routers/7600/install_config/flexwan_config/flexmpls.html#wp1340922

Hope to help

Giuseppe